Publicité
Les langues disponibles
Les langues disponibles
Enabling of regular maintenance activation
N.B: Parameter visible if any password other than the default password is set (Parameter
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
When the manoeuvre hour limit (set by
1500 manoeuvre hours).
IMPORTANT: "manoeuvre" means every motor opening activation .
The message
(1 s on / 4 s off) until system maintenance is performed and the alarm is reset.
To reset the alarm, release the protection by inputting the password (
is displayed, followed by the messages
is displayed.
The number of hours
is stored by the control unit, and the count is reset.
N.B.: When 8000 hours of operation are exceeded, the maintenance alarm is disabled entirely.
Disabled.
Maintenance enabled for a period = parameter value
Maintenance enabled for a period = parameter value
Adjustment of regular maintenance activation hour counter
N.B: Parameter visible with parameter
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
Disabled.
from 10 to 800 hours with parameter
from 100 to 8000 hours with parameter
Maximum limit: 8000 hours (beyond this value the maintenance alarm is disabled entirely).
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
P1
P2
Warning! Restoring default settings cancels all settings made previously except for parameter
that all parameters are suitable for the installation.
The default factory settings may also be restored using the
• Turn off the power.
• Press and hold the
(up arrow) and
• The display flashes after 4 s
• The default factory settings have now been restored.
N.B.: The values shown in the table are indicative only.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
IMPORTANT: "manoeuvre" means every motor activation (total opening or closure / partial opening / step mode, etc.).
Manoeuvres performed.
Example:
x100 = 12.300 manoeuvres.
and
) is exceeded, the visual maintenance signal is activated (e.g. every
appears on the display and the alarm is not reset.
x10 hours.
x100 hours.
or
.
.
.
x4 s
(down arrow) button until the unit switches on.
.
) and press TEST for 5 s. The message
(up arrow) and
(down arrow) buttons as follows:
to
.
Example:
to
multiplied by 100.
÷
).
77
Publicité
