Publicité
Les langues disponibles
Les langues disponibles
Lubricating cables and joints
The condition of the outer sheath of the throttle/cold start
cables should be checked at regular intervals. The sheath
should show no signs of squeezing or cracking. Work the
controls to make sure the inner cables slide smoothly
inside the sheath: if you feel any friction or hard spots,
have the cable replaced by a Ducati Dealer or Authorized
Workshop.
In the case of the throttle cable, open the twistgrip by
undoing the two screws (1, fig. 71), and grease the end of
1
E
the cable and the pulley with SHELL Advance Grease or
Retinax LX2.
Warning
fig. 59
When refitting the cover, be sure to slide the cables
onto the suitable pulley.
Reinstall the cover and tighten down the screws (1) to
10 Nm.
To ensure smooth operation of the side stand joint, clean
off any dirt and apply SHELL Alvania R3 at all points
exposed to friction.
65
Publicité
