Publicité
Å
ı
2
IGNITION SYSTEM
SPARK GAP TEST
1. Disconnect the spark plug cap from spark
2. Remove the ignition coil cap.
3. Connect the dynamic spark tester 1
Å For USA and CDN
ı Except for USA and CDN
4. Kick the kickstarter crank.
5. Check the ignition spark gap.
6. Start engine, and increase spark gap until
COUPLERS, LEADS AND IGNITION COIL
CONNECTION INSPECTION
1. Check:
ENGINE STOP SWITCH INSPECTION
1. Inspect:
Tester (+) lead → Black/White lead 1
Tester (–) lead → Black lead 2
2
1
B
B/W
1
No continuous while being pushed → Replace.
Continuous while being freed → Replace.
6 - 4
ELEC
plug.
(ignition checker 2) as shown.
Ignition coil 3
G
Spark plug 4
G
misfire occurs. (for USA and CDN only)
Minimum spark gap:
6.0 mm (0.24 in)
Couplers and leads connection
G
Rust/dust/looseness/short-circuit →
Repair or replace.
Ignition coil and spark plug as they are
G
fitted
Push in the ignition coil until it closely
contacts the spark plug hole in the cyl-
inder head cover.
Engine stop switch conduct
G
B/W
B
1
2
PUSH IN
FREE
–
+
Tester selec-
tor position
Ω × 1
Publicité
