Publicité
REAR BRAKE PAD INSULATOR INSPECTION/
Å
BRAKE FLUID LEVEL INSPECTION
ı
3. Inspect:
Brake fluid level
G
Refer
to
INSPECTION" section.
4. Check:
Brake pedal operation
G
A softy or spongy feeling → Bleed
brake system.
Refer
to
BLEEDING" section.
EC36b000
REAR BRAKE PAD INSULATOR
INSPECTION
1. Remove:
Brake pad
G
Refer to "REAR BRAKE PAD INSPEC-
TION AND REPLACEMENT" section.
2. Inspect:
Rear brake pad insulator 1
G
Damage → Replace.
BRAKE FLUID LEVEL INSPECTION
1. Place the brake master cylinder so that
its top is in a horizontal position.
2. Inspect:
Brake fluid level
G
Fluid at lower level → Fill up.
a Lower level
Å Front
ı Rear
Recommended brake fluid:
DOT #4
WARNING
Use only designated quality brake fluid to
G
avoid poor brake performance.
Refill with same type and brand of brake
G
fluid; mixing fluids could result in poor
brake performance.
Be sure that water or other contaminants
G
do not enter master cylinder when refill-
ing.
Clean up spilled fluid immediately to
G
avoid erosion of painted surfaces or plas-
tic parts.
3 - 30
INSP
ADJ
"BRAKE
FLUID
LEVEL
"BRAKE
SYSTEM
AIR
Publicité
