Maintenance; Information About Scrapping; Environmental Information - Corghi EXACT 70 II Manuel D'utilisation

MAINTENANCE

WARNING
CORGHI declines all liability for claims de-
riving from the use of non-original spares or
accessories.
WARNING
Before making any adjustments or performing
maintenance, disconnect the electrical supply
from the machine and make sure that all moving
parts are suitably immobilised.
Do not remove or modify any parts of this equip-
ment except in the case of service interventions.
ATTENTION
Keep the working area clean.
Never use compressed air and/or jets of water
to remove dirt or residues from the equipment.
When cleaning, take care to avoid creating and
raising dust as far as possible.
Never use solvents to clean the aligner or
sensors.
- Store the sensors carefully in a dry place,
to avoid loss of calibration with consequent
measurement inaccuracy.
- Calibrate the sensors at least once every six
months.
- Keep the sensor mounting clamp guides clean.
- Keep the turntables and the oscillating
footboards on which the vehicle alignment
is performed perfectly clean and do not oil
or grease them.
INFORMATION ABOUT
SCRAPPING
If the machine is to be scrapped, first separate
the electrical, electronic, plastic and ferrous parts.
Then dispose of them separately as prescribed
by law (Fig.61-62-63).
Operator's Manual EXACT 70 II
ENVIRONMENTAL
INFORMATION
The disposal procedure described below must
only applies to machines with the symbol of
the waste bin with a bar across it
their data plates.
This product may contain substances which may
cause damage to the environment and human
health if not disposed of properly.
We are therefore providing you with the informa-
tion below in order to prevent these substances
from being released into the environment, and
to improve the use of natural resources.
Electrical and electronic equipment must not
be disposed of with ordinary municipal waste;
it must be disposed of separately by authorised
facilities.
The symbol of the waste bin with a bar across it,
which appears on the product and on this page,
reminds users that the product must be disposed
of properly at the end of its working life.
This prevents the inappropriate disposal of
the substances which this product contains, or
the improper use of some of them, from having
hazardous consequences for the environment
and human health. It also helps to ensure the
recovery, recycling and reuse of many of the
materials these products contain.
To allow this, the producers and distributors of
electrical and electronic equipment organise
special systems for the collection and disposal
of such equipment.
At the end of the product's working life, contact
your dealer for information about disposal
procedures.
When you purchase this product, your dealer will
also inform you that you may return another worn-
out appliance to him free of charge, provided it
is of the same type and has provided the same
functions as the product just purchased.
Anyone disposing of the product otherwise than
as described above will be liable to prosecution
under the legislation of the country where the
on
EN
87