Introduction; Transport, Storage And Handling; Equipment Transport Conditions; Ambient Conditions For Storage Of The Equipment - Corghi EXACT 70 II Manuel D'utilisation

INTRODUCTION

The purpose of this manual is to furnish the
owner and operator of this equipment with a set
of practical and safe instructions for the use and
maintenance of the wheel aligner.
Follow all the instructions carefully and your
equipment will assist you in your work and give
lasting, efficient service in keeping with CORGHI
traditions.
The following points define the levels of danger
regarding the equipment, associated with the
warning captions found in this manual:
DANGER
Immediate dangers which cause serious injury
or death.
WARNING
Dangers or unsafe procedures that can cause
serious injury or death.
ATTENTION
Dangers or unsafe procedures that can cause
minor injuries or damage to property.
Read these instructions carefully before powering
up the equipment. Conserve this manual and all
illustrative material supplied with the equipment
in a folder near the equipment where it is read-
ily accessible for consultation by the operators.
The technical documentation supplied is consid-
ered an integral part of the equipment; in the
event of sale all relative documentation must
remain with the system.
The manual is only to be considered valid for
the equipment of the model and with the serial
number indicated on the nameplate applied to it.
WARNING
Adhere to the contents of this manual: the
manufacturer declines all liability in the case
of uses of the equipment not specifically de-
scribed in this manual.
NOTE
Some of the illustrations in this manual have been
taken from photographs of prototypes: standard
production systems may differ in some details.
These instructions are intended for people with
a fair level of mechanical knowledge. We have
therefore not considered it necessary to describe
every single operation, such as the procedure for
loosening or tightening fixing devices, etc. Never
carry out operations which exceed your level
of operating skill, or of which you do not have
experience. If assistance is required, contact an
Operator's Manual EXACT 70 II
authorised service centre.
WARNING
The wheel aligner is a measuring tool, so the
suggestions for the adjustments to be made on
the vehicle (animations or fixed help-on-line
contained in the aligner) are merely indicative. In
any case, before making any intervention on the
vehicle, the operator must examine and be aware
of the regulations (in other words the instructions
or recommendations of the manufacturer), and
always make the adjustments in compliance with
such priority indications.
The company declines all responsibility deriving
from the execution of such regulations and any
damage that could eventually result.
TRANSPORT,
STORAGE AND

HANDLING

Equipment transport conditions

The aligner must be shipped in its original
packing and stowed in the position indicated
on the outside.
Ambient conditions for storage of
the equipment
Relative humidity 20% - 80%
Temperature range -10° - +60°C.
WARNING
To avoid damage, never place other items on
top of the packaging.
Handling
To move the packing, insert the tines of a fork-lift
truck into the slots on the base (pallet) (fig.1).
Remove the three fixing brackets (A fig.1)
To move the equipment, use the wheels of the
aligner; to lift it, insert the tines of a fork-lift truck
under the lower base of the cabinet, keeping
them close to the wheels of the aligner (fig.2).
Take care not to break the door.
ATTENTION
Keep the original packaging for use if the equip-
ment has to be transported again in the future.
EN
49