Remote Control (Fig.22); Personal Computer; Operator Interface; Icons - Corghi EXACT 70 II Manuel D'utilisation

The release lever (A fig.26) can be used to
lower the sensor connection point to prevent
particularly low spoilers from interfering with
the measurements (fig.27).
To fix the sensor at the required height, tighten
the fixing screw (B fig.26) with the sensor in the
position of choice.
These clamps are also able to operate on cars
with wrap-around fenders (Citroen); in this case,
mount the clamps in the horizontal position.
On small-diameter rims, always perform compen-
sation with the clamps in the horizontal position.

Remote control (fig.22)

The Enter (N) and Esc (O) keys and the four arrows
(P) duplicate the functions of the same keys on
the keyboard and the central unit control panel.
It is powered by an ordinary 9V DC battery.

PERSONAL COMPUTER

Wait a few seconds to allow the monitor to switch
on and the computer to load the program.
The personal computer, and thus the entire wheel
aligner, can only be switched off using the com-
mand provided in the wheel alignment program.
IMPORTANT
Switching off the personal computer without
using the command provided may damage the
software installation.
IMPORTANT
When the wheel aligner is switched off using
the software command, the PC, the monitor and
the printer switch to standby status. To switch
off these devices completely, use either the
relative on and off buttons, or the PC feeder
switch (switch marked C turned to 0), or cut off
the wheel aligner power supply at the mains.
Keep the original GHOST and aligner software
CD-ROMs for future system upgrades.
IMPORTANT
The software on the CD-ROM is the property of
Corghi S.p.A. and can be used only with the per-
sonal computer supplied with the equipment.
Operator's Manual EXACT 70 II
OPERATOR
INTERFACE
Commands and information for moving around
the vehicle wheel alignment program.

Icons

An icon is a key on the screen which performs a
specific action when it is selected. This function
is the same throughout the procedure.
The icon's function is identified by a graphic
symbol; a brief comment is also provided in
the feedback bar.
Move to the icons, using the keys ←, →, ↑, ↓ and
select them with ↵.
If the icon selected has a sub-menu, it will open
vertically and the icon selected will be replaced
by . Use this icon or the ESC key to close
the menu.
identifies additional icons in the menu
for display.
Icons which are not active are plain grey in colour.

Main menu

Start Begins the vehicle alignment
procedure.
Alignment mode Selects the guided
wheel alignment procedure: quick, complete
or customised.
Alignment procedure Selects the
wheel alignment procedure: quick, complete
or customised.
Databank and job management Tools
for management of the jobs archive and user
databank.
Set-up and maintenance Gives access
to the utility functions for wheel aligner set-up
and maintenance.
Service programs Gives access to
the wheel aligner service and troubleshooting
functions.
EN
57