Corghi EXACT 70 II Manuel D'utilisation page 75

the front caster, front camber, front half toe, front
total toe and front set-back angle values.
In the front axle measurement screen
switches between the two pages of values.
returns to normal display mode.
For adjustment of the caster the data, only avail-
able if the steering lock measurement procedure
has been carried out, must be on the screen.
The data are only shown when the front sensors
are levelled.
N.B. On exit from this procedure the caster values
are saved automatically.
Saving of these values means that the procedure
can always be restarted from the last adjust-
ment made.
If a new steering lock procedure is performed, the
values recalled will be the last ones measured
during the steering lock sequence.
(12) Second angle measurement
with steering locked
Repetition of the steering axis angle measure-
ment allows you to check whether errors have
been introduced during adjustment of the caster.
The procedure is exactly the same as the first
time the caster, king pin and steering angle dif-
ference values were measured.
Performing the steering lock procedure or
moves the program straight on to front
axle measurement.
(13) Second front axle
measurement
Repetition of the front axle measurement proce-
dure allows any corrections to the adjustments
already made.
(14) Printout of the data measured
(fig.42)
To access this function from the rest of the
program select the
The printout serves to inform the customer about
the operations performed and as a reference for
subsequent checks on the vehicle.
Fill in the heading of the job record
Operator's Manual EXACT 70 II
icon or the F4 key.
and print and/or save the job done using the
appropriate commands.
When the printout is complete, end the job and
return to the main menu
job for any further adjustments.
(15) Graphic printouts
The current printed report, supplied in alpha-
numeric form, has now been updated with the
addition of two annexes consisting of graphics
which illustrate some information about the
vehicle in intuitive form.
The first annex, entitled "Vehicle Condition",
shows the toe, camber and setback values before
and after adjustment.
The second annex, entitled "Chassis Condition",
lists the set-back, track difference, wheel base
difference, side offset and offset values of the
axles after adjustment.
The "Print \ Type" field of the user set-up can
be set appropriately to select the annexes to
be printed:
• "Alphanumeric" prints the alphanumeric pages
only.
• "Vehicle Condition" prints the alphanumeric
report and the vehicle condition annex. This
setting is indicated by the
print page status bar.
• "Chassis Condition" prints the alphanumeric
report and the chassis condition annex. This
setting is indicated by the
print page status bar.
• "Complete" prints the alphanumeric report
and both annexes.
The set-up can be varied on the print page.
PRINT ON FILE. If selected, allows the
data to be printed in a CSV (Comma Separated
Values) file.
COLOUR PRINT. If selected, the printed
reports will be in colour.
PRINT PRELIMINARY CHECKS. The
or restart the
icon in the
icon in the
EN
75