Fronius TransTig 2200 Instructions De Service page 170

Available set-up PPU .... PushPull-Unit (only with optional cold-wire feeder)
parameters
(continued) I-c ....... I (current) correction ... I
Important! The I
welding torch.
In the jobs, all the settings are permanently saved, i.e. cannot be changed. However,
the set-up parameter "I-c" permits subsequent correction of the main current I
JobMaster TIG.
Example
The set-up parameter "I-c" has been set to 30 %:
-
Important! Every subsequent correction of the main current I
when the power source is switched off.
ACS .... Automatic current switchover ... (to main current) ... ON / OFF, factory setting:
If the "ACS" set-up parameter is set to "ON":
-
-
-
Important! If the "ACS" parameter (see the section headed "The set-up menu: Level
2") is set to OFF, then the most recently selected parameter remains active during
welding.
-
-
OFF / 1 to 30 %, factory setting: OFF
correction range only applies to job retrieval from the JobMaster TIG
1
The welding amperage I
directly from the JobMaster TIG welding torch.
ON
the parameter I (main current) will automatically be selected after the start of
1
welding
settings can be made immediately for the main current I
the control panel indicates which position has been reached in the welding process
by means of a dimmed display of the parameters (I
The last parameter to be selected can be adjusted immediately.
No automatic selection of parameter I
62
correction range for job retrieval ...
1
can then be decreased or increased by up to 30 %,
1
takes place
1
on the
1
is reset (i.e. cancelled)
1
1
, t , ...)
S up