Level 1: Rod-Electrode Set-Up Parameters; Accessing - Fronius TransTig 2200 Instructions De Service

Level 1: Rod-electrode set-up parameters

Accessing

-
-
-
Important! The first parameter to be displayed is always the one that was the last to be
selected the last time the set-up menu was accessed.
Selecting and -
altering the set-
up parameter -
Saving and -
exiting
Available set-up HCU ... Hot-start current ... 0 to 100 %, factory setting: 50 %
parameters
Hti ...... Hot-current time ... 0 to 2.0 s, factory setting: 0.5 s
dYn .... dynamic ... arc-force dynamic correction ... 0 to 100, factory setting: 30
FAC .... Factory ... To reset the welding machine
Press and hold the Store button (13) for 2 s to reset the machine to the factory settings.
When the display reads "PrG", the welding machine has been reset.
Important! When the welding machine is reset, all the personal settings in Level 1 of
the set-up menu are lost. Jobs are not deleted when the welding machine is reset -
these are preserved. The parameter settings in the second level of the set-up menu
(2nd) are also not deleted.
2nd ..... Second level of the set-up menu (see "The set-up menu: Level 2")
Press the "Mode" button (1) to select the "Rod-electrode (MMA) welding" mode (5)
(5)
(1)
While pressing and holding the Store button (13), press the "Mode" button (1)
The first set-up parameter is displayed (e.g. "HCU")
Select the desired set-up parameter with the parameter selection buttons (8) and
(9).
Alter the value of the set-up parameter with the adjusting dial (7)
Press the Store button (13)
58