Fronius TransTig 2200 Instructions De Service page 158

Retrieving a job Important! When you retrieve a job directly from the power source, you can also select
(continued) vacant program locations (symbolised by "- - -"). From the JobMaster TIG torch, on the
other hand, you can only select program locations that have already been programmed.
-
When you retrieve jobs with the JobMaster TIG welding torch, 'groups' of jobs are
defined automatically. The individual groups can be separated from one another by
vacant memory locations.
-
Fig.27 Example of job retrieval with the JobMaster TIG welding torch
-
Important! It is not possible to change group while welding is in progress.
Start welding - during welding you can always change to another job, without
interruption.
Use the parameter settings button(s) (31) on the JobMaster TIG welding torch to
change between the jobs contained in one particular group
(31)
Gruppe 1
To change to another group of jobs with the JobMaster TIG welding torch:
- Press the parameter settings button (31) for longer than 2 s
- This changes over to the next group up (or down)
- When you change to another
process, this finishes Job Mode.
(31)
Gruppe 2
50
(31)
Gruppe 3
(31)