Fronius TransTig 2200 Instructions De Service page 129

JobMaster TIG
welding torch
(continued)
(31) Parameter settings button ... for altering the selected parameter
(32) Torch trigger ... Pull this back to start the welding operation.
(37) Display ... for indicating the parameter values and for outputting service codes.
Warning! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described here until you have read and
completely understood the whole of the "Operating Instructions" manual.
- To decrease the parameter: Pull the parameter settings button back
- To increase the parameter: Push the parameter settings button forward
For more detailed information on how to control the welding operation from the
torch trigger, please see the section headed "TIG operating modes".
(33) Cap-shaping indicator ... lights up when "TIG-AC welding with cap shaping"
has been selected.
The cap-shaping function can also be activated by pushing forward the torch
trigger (32). Precondition: The TIG-AC welding process must have been
selected.
Important! The cap-shaping function cannot be activated while welding is in
progress. For more detailed information on the cap-shaping function, please
see the section headed "TIG welding".
(34) Welding-current parameter ... for setting the desired welding current
(35) JOB-n O parameter ... for recalling the desired job
(36) Freely selectable parameter ... a parameter of the user's own choice can be
assigned to this button.
The freely selectable parameter is assigned by means of set-up parameter
"E-P". For a description of set-up parameter "E-P", please refer to the section
headed "The set-up menu: Level 2", sub-section "TIG set-up parameters".
Here, you will also find a list of the parameters which are available for
selection, i.e. which can be assigned to this button.
Important! Each of the service codes which may be outputted on the display (37)
has the same meaning as the service code which is displayed at the same time on
the control panel. The service codes displayed on the control panel are described in
the "Troubleshooting" section.
21