Deleting A Job; Retrieving A Job - Fronius TransTig 2200 Instructions De Service

Deleting a job

A job that has been stored to a program location can also be deleted again. To delete a
job, proceed as follows:

Retrieving a job

Once programmed, all jobs can be retrieved in Job Mode. To retrieve a job, proceed as
follows:
-
-
(4)
(1)
To view the settings programmed in this job, use the "Parameter selection" buttons
(8) and (9).
The operating mode and process (MagicWave 1700/2200) of the stored job are
also displayed.
- Briefly press the Store button (13) to
change to the job menu. The first
vacant program location is now
indicated.
- With the adjusting dial (7), select the
job to be deleted - the DEL symbol
lights up on the "Gas test" button
(14).
- Press and hold the "Gas test" button
(14). The left-hand display reads
"dEL" - the job is deleted.
- "nPG" appears on the left-hand
display to indicate that the job is now
deleted. Release the "Gas test"
button (14).
- Briefly press the Store button (13) to
exit from the job menu.
- With the "Mode" button (1), select
"Job mode" (4) as the operating
mode. The display now shows the
last job to be used.
- Select the desired job, either with the
adjusting dial (7) or the JobMaster
TIG welding torch.
49