2-Step - Fronius TransTig 2200 Instructions De Service

2-step

Important! When 2-step mode has been selected, the spot-welding status indicator on
the control panel must not be lit up.
The factory setting (i.e. in which the power source is delivered) is: Parameter Spt "OFF".
-
-
Fig.11 2-step mode
Select 2-step mode (2)
Spot-welding status indicator: If the spot-welding status indicator is lit up, set
the set-up parameter SPt to "OFF" (see: "The Set-up menu: Level 1")
Welding: Pull back and hold the torch trigger
End of welding: Release the torch trigger
I
GPr t
up
I
1
28
t
t G-L
down
G-H