Fronius TransTig 2200 Instructions De Service page 125

TransTig 2200 (11) Welding voltage display ... for indicating the actual welding-voltage value on the
control panel
(continued)
(12) HOLD indicator ... every time you finish a welding operation, the actual values for
(13) Store button ... for storing jobs. Is also used for accessing the Set-up menu.
(14) Gas-test button ... for setting the required gas-flow rate on the pressure regulator.
(15) Overtemperature indicator ... lights up if the power source overheats (e.g.
right-hand display.
Where one of the TIG-welding modes has been selected, the right-hand display
reads "0.0" before the start of welding. Where the "Rod electrode (MMA) welding"
mode has been selected, there is first a 3-second time-lag, after which the value for
the open-circuit voltage "50V" is displayed.
Important! The value of 50 V indicated where the "Rod electrode (MMA)" process
has been selected refers to the mean value of the pulsed open-circuit voltage.
welding current and voltage are stored, and the "Hold" indicator lights up.
The "Hold" indicator refers to the last value reached by the Main current I
as any other parameter is selected, the "Hold" indicator goes out. The "Hold" values
will continue to be available, however, if Parameter I
The "Hold" indicator is cancelled whenever:
- a new welding operation is started
- the Main current I is adjusted
1
- the operating mode is changed
- the process is changed
Important! If the main-current phase was never reached, or if a pedal remote-
control unit was being used, no "Hold" values are outputted.
After you press this button, gas will flow out for 30 s. Press the button again to stop
the gas test-flow before the 30 seconds are up.
because the duty cycle has been exceeded). For more information on this, see the
"Troubleshooting" section.
is selected once again.
1
17
. As soon
1