Level 1: Ac / Polarity Reversal Set-Up Parameters; General Remarks; Accessing; Selecting And Altering The Set-Up Parameter - Fronius TransTig 2200 Instructions De Service

Level 1: AC / polarity reversal set-up parameters

General remarks

The AC / polarity reversal set-up parameters are only available on the MagicWave 1700
and MagicWave 2200 power sources.
-

Accessing

-
-
Important! The first parameter to be displayed is always the one that was the last to be
selected the last time the set-up menu was accessed.
-
Selecting and
altering the set-
-
up parameter
Saving and -
exiting
Available set-up ACF .... AC-frequency ... Syn / 40 to 250 Hz, factory setting: 60 Hz
parameters Syn ... For mains-network synchronisation of two power sources
FAC .... Factory ... To reset the welding machine
Press and hold the Store button (13) for 2 s to reset the machine to the factory settings.
When the display reads "PrG", the welding machine has been reset.
Important! When the welding machine is reset, all the personal settings in Level 1 of
the set-up menu are lost. Jobs are not deleted when the welding machine is reset -
these are preserved. The parameter settings in the second level of the set-up menu
(2nd) are also not deleted.
2nd ..... Second level of the set-up menu (see "The set-up menu: Level 2")
Press the "Process" button (6) to select the AC welding process
(6)
While pressing and holding the Store button (13), press the "Process" button (6)
The first set-up parameter is displayed (e.g. "ACF")
Select the desired set-up parameter with the parameter selection buttons (8) and
(9).
Alter the value of the set-up parameter with the adjusting dial (7)
Press the Store button (13)
57