Fronius TransTig 2200 Instructions De Service page 123

TransTig 2200 (7) Adjusting dial ... for altering parameters. If the indicator is lit up on the adjusting
control panel
(continued)
(8) and (9) Parameter selection buttons ... for selecting the parameters
It is also possible to change parameters by means of the parameter selection buttons
(8) and (9) while the welding operation is in progress.
dial, then the selected parameter can be altered.
Available parameters where 2-step mode (2) has been selected:
Starting current I
S
Important! The starting current I
"TIG DC- welding" operating modes.
Upslope t ............................ 0.0 to 9.9 s, factory setting: 0.1 s
up
Important! The upslope t
modes.
Main current I ...................... TransTig 2200: 3 to 220 A
1
Downslope t .................... 0.0 to 9.9 s, factory setting: 1 s
down
Important! The downslope t
operating modes.
Final current I ...................... 0 to 100 % of main current
E
Electrode diameter ............... 0 to 4.0 mm, factory setting: 2.4 mm
Available parameters where 4-step mode (3) has been selected:
Starting current I
S
Important! The starting current I
"TIG DC- welding" operating modes.
Upslope t ............................ 0.0 to 9.9 s, factory setting: 0.1 s
up
Important! The upslope t
modes.
Main current I ...................... TransTig 2200: 3 to 220 A
1
Reduced current I
Downslope t .................... 0.0 to 9.9 s, factory setting: 1 s
down
Important! The downslope t
operating modes.
................. 0 to 100 % of main current I
Factory setting: 35%
is saved separately for the "TIG-AC welding" and
S
is saved separately for the 2-step and 4-step operating
up
is saved separately for the 2-step and 4-step
down
Factory setting: 30 %
................. 0 to 100 % of main current I
Factory setting: 35%
is saved separately for the "TIG-AC welding" and
S
is saved separately for the 2-step and 4-step operating
up
............... 0 to 100 % of main current I
2
Factory setting: 50%
is saved separately for the 2-step and 4-step
down
15
1
1
1