Fronius TransTig 2200 Instructions De Service page 119

MagicWave 1700/
2200 control
panel
(continued)
Balance (only with TIG-AC)... -5 / +5, factory setting: 0
Electrode diameter ............... 0 to 4.0 mm, factory setting: 2.4 mm
Available parameters where 4-step mode (3) has been selected:
Starting current I
S
Important! The starting current I
"TIG DC- welding" operating modes.
Upslope t ............................ 0.0 to 9.9 s, factory setting: 0.1 s
up
Important! The upslope t
modes.
Main current I ...................... MagicWave 1700: 3 to 170 A
1
Reduced current I
Downslope t .................... 0.0 to 9.9 s, factory setting: 1 s
down
Important! The downslope t
operating modes.
Final current I ...................... 0 to 100 % of main current
E
Balance (only with TIG-AC). -5 / +5, factory setting: 0
Electrode diameter ............... 0 to 4.0 mm, factory setting: 2.4 mm
Available parameters where "Job mode" (4) has been selected:
In "Job mode", the parameters that apply to the operating mode that has been
stored in the selected job are made available. In addition, the following parameter is
also available:
Job number .......................... for selecting the desired job
Available parameters where the "Rod electrode (MMA) welding" mode (5) has been
selected:
Main current I ...................... MagicWave 1700: 10 to 140 A
1
-5 highest fusing power,
lowest cleaning action
+5 highest cleaning action,
lowest fusing power
................. 0 to 100 % of main current I
Factory setting: 35%
is saved separately for the "TIG-AC welding" and
S
is saved separately for the 2-step and 4-step operating
up
MagicWave 2200: 3 to 220 A
............... 0 to 100 % of main current I
2
Factory setting: 50%
is saved separately for the 2-step and 4-step
down
Factory setting: 30 %
-5 .... highest fusing power,
lowest cleaning action
+5 ... highest cleaning action,
lowest fusing power
MagicWave 2200: 10 to 180 A
11
1
1