Transtig 2200 Control Panel - Fronius TransTig 2200 Instructions De Service

TransTig 2200
control panel
(8)
Fig.4
On the TransTig 2200 power source, the TIG-DC and rod electrode DC welding
processes are available. The following processes and functions are not available and
cannot be retro-fitted:
-
-
-
-
Important! To change over from the rod electrode DC- welding process to the rod
electrode DC+ welding process on the TransTig 2200 power source, reconnect the
electrode holder and the earthing (grounding) cable to the opposite welding sockets (i.e.
swap them over - see the section headed "Rod electrode (MMA) welding").
(1) Mode button ... for selecting the operating mode:
Warning! Operating the machine incorrectly can cause serious injury and dam-
age. Do not use the functions described here until you have read and completely
understood the whole of the "Operating Instructions" manual.
(15) (10)
(13)

TransTig 2200 control panel

TIG-AC welding
RPI ignition for the TIG-DC welding process
rod-electrode AC welding
switchover facility between the rod electrode DC- and rod electrode DC+ welding
processes
(2) 2-step mode
(3) 4-step mode
(4) Job mode
(5) Rod electrode (MMA) welding
Important! If you select the "Rod electrode (MMA) welding" mode (5), the welding
voltage will only be available after a 3-second time-lag.
14
(12) (11)
(7) (9)
(3) (2) (4)
(14) (1)
(5)