Fitting The Handle For The Separator; Assembling The Electrode Holder; Adding Grinding Fluid - Fronius TIG Grinder Instructions De Service

Fitting the handle
for the separator
Assembling the
electrode holder
Adding grinding
fluid
1
2
(1) (2)
Screw the handle for the separator into
1
the left side of the device and tighten it
Insert the clamping sleeve (2) with the
1
diameter of the electrode to be ground
into the lower part (3) of the electrode
holder
Screw the top part (1) of the electrode
2
holder into the lower part (3), but do not
tighten it
(3)
Check that the key is holding the tank
1
securely in place
Pour the grinding fluid for the grinder
2
through the guide bushing
47