Mounting Door Handle; Attaching Gas Cylinder Retainer Bracket - Pit Boss PBV2G1 Mode D'emploi

15. MOUNTING DOOR HANDLE TO THE
DOOR ASSEMBLY
Parts Required:
1 x Door Handle (#7)
1 x Silicon Washer (#8)
1 X Door Assembly (#10)
2 x #10-24*1/2"(#C)
Installation:
• Attach the Door Handle (#7) with
Silicon Washer (#8) to the Door
Assembly (#10)using 2 x #10-24*1/2"(#C)
as Fig.15 shown.
16. ATTACH GAS CYLINDER RETAINER
BRACKET INTO THE LOWER SMOKER
CABINET ASSEMBLY
Parts Required:
1 x Gas Cylinder Retainer Bracket (#17)
1 X Lower Smoker Cabinet Assembly (#14)
4 x #1/4*1/2"Screw (#B)
Installation:
• Attach the Gas Cylinder Retainer Bracket
(#17) to the Lower
Assembly (#14) using 4 x #1/4*1/2"(#B) as
Fig.16.1 & Fig.16.2 shown.
17. SLIDING WOOD CHIPS BOX WITH LID
ASSEMBLY INTO THE LOWER
SMOKER CABINET ASSEMBLY
Parts Required:
1 x Wood Chip Box Lid (#11)
1 x Wood Chip Box Assembly (#12)
1 X Lower Smoker Cabinet Assembly (#14)
1 X Wood Chip Box (#12.1)
1 X Wood Chip Box Front Panel (#12.2)
1 X Wood Chip Box Handle (#12.3)
2 X #10-24 x 1/2" (#C)
Installation:
•Assemble the Wood Chips Box Handle
(#12.3)and Wood Chips Box Front Panel
(#12.2) onto the Wood Chips Box (#12.1) using
2x #10-24x1/2" (#C) as Fig. 17.1 shown.
•Put the Wood Chip Box Lid (#11) on the Wood
Chip Box Assembly (#12) and slide Wood Chip
Box onto the Wood Chip Box support rails of
Lower Smoker Cabinet Assembly (#14) as
Fig.17.2 shown.
Note: When removing the Wood Chip Box
from the smoker, lift up on the handle and
pull out the Wood Chip Box.
15
Fig.15
Fig.16.1
Fig.16.2
Smoker Cabinet
Fig.17
12
Fig.17.1
#12.3
#12.2 ----
#12.1
Fig.17.2