Placing Control Knob Onto Valve Stem; Sliding Grease Tray Into The Control Panel - Pit Boss PBV2G1 Mode D'emploi

18. PLACING CONTROL KNOB ONTO
VALVE STEM
Parts Required:
1 x Control Knob (#13)
Installation:
• Place Control Knob (#13) over the valve
stem, making certain to align the flat portion
of the stem with the flat portion of the knob
and push the Control Knob (#13) onto the
stem until it is firmly seated. as Fig.18
shown.
19. SLIDING GREASE TRAY INTO THE
CONTROL PANEL
Parts Required:
1 x Grease Tray Assembly(#25)
Installation:
•Slide Grease Tray Assembly (#25) into
the grease tray support rails provided in
the bottom panel as Fig.19 shown.
20. LOOPING ZIP-TIE ONTO THE
RIGHT FRONT LEG
Parts Required:
1 x Zip-tie(#F)
1 x Right Front Leg (#22)
Installation:
•Loop the Zip-tie (#F) through outside
hole of Right Front Leg (#22) as Fig.20
& Fig.20.1 shown.
Fig.18
#13
Fig.19
Fig.20
Fig.20.1
16