Pit Boss PBV2G1 Mode D'emploi page 16

21. Assembly of the 2.2 Gas Smoker
is completed
Warning: This is a stationary
position for gas smoker
assembly with gas cylinder. If
you should want to move the
unit, the gas cylinder mounting
bracket and Regulator QCC1
Connector must be
disconnected prior to moving.
CONNECTING AND DISCONNECTING THE
LP GAS CYLINDER TO/ FROM THE
MOUNTING BRACKET
Connecting the LP cylinder to the
mounting bracket:
Attach the gas Cylinder
Mounting Bracket onto the Cylinder Handle as
Fig. shown and then tighten the Mounting Knob
in clockwise direction by hand.
Disconnecting the LP cylinder from the
mounting bracket: Loosen the Mounting
Knob from the LP gas cylinder handle and
the lift up the cylinder mounting bracket.
17
17
Fig.21
14
Gas cylinder
mounting
bracket
Regulator
QCC1
Connector
Mounting Knob
Cylinder
Handle