Mounting Support Panels To Legs; Mounting Burner Chamber Assembly - Pit Boss PBV2G1 Mode D'emploi

4. MOUNTING SUPPORT PANELS TO
FOUR LEGS
Parts Required:
2 x Support Panel (#19)
1 x Right Front Leg (#22)
1 x Left Front Leg (#21)
1 x Right Rear Leg with Wheel Assembly (#18)
1 x Left Rear Leg with Wheel Assembly (#20)
8 x #10-24*1/2"Screw (#C)
Installation:
• Mount Support Panel (#19)to the Right
Front Leg (#22)and Right Rear Leg with
Wheel Assembly (#18) using 4 x
#10-24*1/2"Screws (#C)as Fig.4 shown.
• Mount Support Panel (#19)to Left Front
Leg (#21)and Left Rear Leg with Wheel
Assembly (#20)using 4 x
#10-24*1/2"Screws (#C)as Fig.4 shown.
5. MOUNTING BURNER CHAMBER
ASSEMBLY TO THE BOTTOM AREA OF
LOWER SMOKER CABINET ASSEMBLY
Parts Required:
1 x Burner Chamber Assembly (#24)
1 x Lower Smoker Cabinet with Control
Panel Assembly (#14)
4 x #10-24*1/2"Screw (#C)
Installation:
• Attach ignition wire onto the pin end of
the Igniter on Control Panel.
Mount Burner Chamber Assembly (#24) to
the bottom area of Lower Smoker Cabinet
with Control Panel Assembly (#14) using 4
x #10-24*1/2"Screws (#C)as Fig.5.1 &
Fig.5.2 shown.
Note: Turn the Lower Smoker Cabinet with
Control Panel and Legs Assembly Right
Side Up as Fig.5.3 shown and tighten all
screws now.
11
Fig.4
Fig.5.1
I I g g n n i i t t i i o o n n w w i i r r e e
Fig.5.2
Fig.5.3
8
# # 1 1 9 9
# # 2 2 4 4
N N o o t t e e : : M M U U S S T T m m a a k k e e s s u u r r e e
t t h h a a t t t t h h e e t t i i p p o o f f t t h h e e v v a a l l v v e e s s
a a r r e e c c o o m m p p l l e e t t e e l l y y I I N N S S I I D D E E
t t h h e e e e n n d d o o p p e e n n i i n n g g o o f f t t h h e e
B B u u r r n n e e r r T T u u b b e e s s . .