Attaching The Grease Shield; Mounting The Cabinet Door Handle, Door Latch; 15. Assembling & Installing The Wood Chip Tray - Pit Boss HAMMERTONE 2 Serie Assemblage Et Fonctionnement

Masquer les pouces Voir aussi pour HAMMERTONE 2 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation:
Remove the washer and wing nut from the packaged logo plate.
Insert the logo plate into the mounting hole on the front of the
cabinet door, place the washer on the thread pole on the inside of the
door, and hand-tighten by hand to secure.
NOTE: The logo plate is supplied with one washer and one wing nut.

13. ATTACHING THE GREASE SHIELD

Parts Required:
Door Grease Shield (#12)
1
x
5
x
#8–32" Screw (#F)
Installation:
Attach the door grease shield to the bottom lip of the cabinet door using
five screws. Take care not to over-tighten to avoid stripping the screws.
NOTE: The holes for the screws need to be self-tapped, as they are
not pre-threaded. If needed, carefully use a drill to start, then finish
tightening with screwdriver by hand.

14. MOUNTING THE CABINET DOOR HANDLE, DOOR LATCH

Parts Required:
1
x
Cabinet Door Handle (#6)
Cabinet Door Latch (#7)
1
x
#10–24x½" Screw (#C)
4
x
Installation:
First, re-mount the cabinet door to the main cabinet by aligning and
securing both hinges. Ensure the door is mounted correctly by testing
it opens freely. Note 14A.
Mount the cabinet door handle onto the front side of the cabinet door
using two screws. Note correct direction in 14B.
Mount the cabinet door latch onto the exterior side of the main
cabinet using two screws. Note 14C.
15. ASSEMBLING & INSTALLING THE WOOD CHIP TRAY
Parts Required:
Wood Chip Tray Lid (#10)
1
x
Wood Chip Tray Assembly (#11)
1
x
2
x
#10–24x½" Screw (#C)
Installation:
First, assemble the wood chip tray assembly by securing the faceplate
and handle using two screws. Next, insert the wood chip tray lid into
the lid slots on the wood chip tray assembly and flip the lid down so it
closes. Note illustrations in 15A.
Slide the assembled wood chip tray into the opening above the control
board on the front panel of the unit. Note 15B.
12
13
14
14A
14B
15A
15B
14C
11

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Pbv2dw131576938

Table des Matières