Parts & Specs; Assembly Preparation; Assembly Instructions; Mounting The Cabinet Door Handle, Door Latch - Pit Boss PB0600SS SIDE SMOKER Manuel De L'utilisateur

PARTS & SPECS
Part# Description
1 Chimney Cap (x1)
2 Chimney Stack (x1)
3 Main Cabinet (x1)
4 Fixed Support A (x1)
5 Cabinet Door Latch (x1)
6 Cabinet Door Handle (x1)
7 Grease Exhaust Tube (x1)
8 Cooking Grid (x3)
9 Cooking Grid Support Brackets (x6)
10 Fixed Support B (x1)
11 Fixed Support C (x1)
A 1/4"-20 x 3/5" Screw (x4)
B 1/4" Washer (x4)
C 1/4" Locking Washer (x4)
D 1/4"-20 x 9/5" Screw (x2)
E 5/32" - 32 x 2/5" Screw (x18)
F 1/4"-20*3/5" Hex Screw (x2)
NOTE: Due to ongoing product development, parts are subject to change without notice. Contact
Customer Service if parts are missing when assembling the unit.
MODEL UNIT ASSEMBLED (WxHxD) WEIGHT
442 MM X 487 MM X 670 MM 18 KG
PB
PB0600SS
/ 17.4 IN. X 19.17 IN. X 26.37 IN. / 39.68 LB
4
1
2 9
3
8
5
6
4
11
7
10
A B C
D E F
COOKING AREA TEMPERATURE RANGE
MAIN - 1,599.7 CM² / 247.95 IN²
38-232°C
ADDITIONAL RACKS - 2,979.6 CM² / 461.84 IN²
/ 100-450°F
TOTAL - 4,579.3 CM² / 709.79 IN²

ASSEMBLY PREPARATION

Parts are located throughout the shipping carton, including underneath the smoker. Inspect the smoker, parts, and hardware
blister pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the
grill before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not
attempt to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Service for
parts: Monday through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver, wrench and level. Tools not included.

ASSEMBLY INSTRUCTIONS

IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed.
1. MOUNTING THE CABINET DOOR HANDLE,
DOOR LATCH
Parts Required:
1 x Main Cabinet (#3)
1 x Cabinet Door Handle (#6)
1 x Cabinet Door Latch (#5)
7 x Screw (#E)
Installation:
• Place a piece of cardboard on the floor to prevent
scratching the unit and parts during assembly.
• Mount the Cabinet Door Handle onto the front side of
the Cabinet Door using four screws.
• Mount the Cabinet Door Latch onto the Exterior side
of the Main Cabinet using three screws.
1
3
6
E
6
5
E
5