Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
13. MOUNTING SMOKER DOOR HANDLES
Parts Required :
1
x
Smoker Door Handle (#38)
Lid Handle Standoffs (#7)
2
x
Smoker Door (#40)
1
x
4
x
M6x35 mm Screws (#E)
Installation :
Mount one Smoker Door Handle and two Large Handle
Standoffs to the Smoker Door .
Use: 4 x M6x35 mm Screws
See Fig. 13.1 and Fig. 13.2.
Note: Slots on both side of Smoker Door Handle must
be inserted into the embossed area on inside area of
Handle Stand-off as Fig. 13.1 shown.
14. INSTALLING THE DOOR THERMOMETER
Parts Required :
1
x
Smoker Thermometer (#39)
Smoker door Assembly (#40)
1
x
Note: The Thermometer is supplied with one fiber
washer and one wing nut.
Installation :
•
Insert Smoker Thermometer probe through the
mounting hole in the front of the Smoker Door
Assembly. From the inside door, place fiber washer and
wing nut onto the mounting thread pole and tighten
by hand and do not over tighten.
See Fig. 14.
15. MOUNTING THE SMOKER DOOR HINGES
Parts Required :
Smoker Door Hinges (#50)
2
x
1
x
Smoker Door (#40)
8
x
M4x8 mm White Zn Screws (#G)
Installation :
•
Mount two Smoker Door Hinges to the Smoker Door.
Use: 8 x M4x8 mm Screws
See Fig. 15.
FIG. 13.1
7.1
38
FIG. 13.2
E
FIG. 14
39
FIG. 15
40
50
G
7.2
E
40
39
40
CORRECT
DIRECTION
50
G
15
Publicité
Chapitres
Table des Matières
