Lighting Instruction - Pit Boss PBV2G1 Mode D'emploi

Operating Instructions

LIGHTING INSTRUCTION:

•
READ ALL INSTRUCTION BEFORE LIGHTING.
• OPEN DOOR DURING LIGHTING.
OPEN CYLINDER MAIN GAS VALVE.
•
•
PUSH AND TURN BURNER VALVE COUNTER-CLOCKWISE TO
TO "HIGH" POSITION "
•
PUSH IGNITOR BUTTON UNTIL BURNER IGNITES.
•
IF IGNITION DOES NOT OCCUR WITHIN 5 SECONDS, TURN VALVES
TO OFF POSITION "
LIGHTING PROCEDURE.
Note: Use the viewing holes on the sides of the smoker
Support Panel to make sure both burners flames are lit.
FLAME OPERATION INSTRUCTIONS:
•
TURN BURNER VALVE TO "LOW" POSITION "
•
TURN BURNER VALVE "HIGH" POSITION "
•
TURN BURNER VALVE "OFF" POSITION "
Operating Instructions for Dual Burner System
1. When the control knob is set to the
wood chips tray the fastest and also give you the Highest Temperatures inside your smoker.
2. When the control knob is set to the MED
the "Low" setting and the smoke burner is on. This will give you smoke from your wood chips tray quickly and give you the
intermediate temperature range inside your smoker.
3. When your control knob is set to the "Low"
automatically Shut off. This will give you smoke from your wood chips tray in approx. 10min depending on how long you
soaked your wood chips. This will also give you lowest temperature inside your smoker.
4. If you have your control knob set on "Low" setting and desire higher temperature, you must rotate your control knob
90 degree to the "MED" setting to the "High" setting.
LP Cylider Capacity and Specifications:
The 20 lb (9.1 kg). LP cylinder used with this smoker must conform to the following requirements.
Diameter- 12" (30.5cm)
19
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
".
", WAIT 5 MINUTES, AND REPEAT
" IF NEEDED.
" IF NEEDED.
". IF NEEDED.
HIGH setting
HIGH
setting, both burners are still lit. The main Burner is on
Med
Height 18" (45.7cm)
Your Pit Boss Gas Smoker was designed with a
Single Valve Control/ Dual Burner System. The
Smoke Burner
Top burner is a low BTU smoke burner and the
bottom Burner is a Higher BTU main burner. The
Main Burner
following is the recommended operation:
setting, both burners lit. This will give you smoke from your
Low
setting, only the smoke burner will be lit. The main burner will
Install LP-Cylinder
on the unit as
shown below