Attaching Door Assembly; Inserting Heat Indicator Into Door Assembly; Mounting Door Latch Assembly - Pit Boss PBV2G1 Mode D'emploi

12. ATTACHING DOOR ASSEMBLY INTO
THE UPPER SMOKER CABINET
ASSEMBLY
Parts Required:
1 x Door Assembly (#10)
1 X Upper Smoker Cabinet Assembly (#2)
Installation:
•Attach Door Assembly (#10)into the Upper
Smoker Cabinet Assembly(#2) as Fig.12
shown.
13. INSERTING HEAT INDICATOR INTO
THE DOOR ASSEMBLY
Parts Required:
1 x Door Assembly (#10)
1 X Heat Indicator (#9)
Note: The Heat Indicator is supplied with
one fiber washer and one wing nut.
Installation:
•Insert Heat Indicator (#9) probe through
the mounting hole in the front of the Door
Assembly(#10). From the inside of the
door, place fiber washer and wing nut
onto the mounting thread pole and
tighten by hand as Fig.13 shown.

14. MOUNTING DOOR LATCH ASSEMBLY

TO THE UPPER SMOKER CABINET
ASSEMBLY
Parts Required:
1 x Door Latch Assembly (#6)
1 X Upper Smoker Cabinet Assembly (#2)
2 x #10-24*1/2"(#C)
Installation:
•Attach the Door Latch Assembly (#6) to
the Upper Smoker Cabinet Assembly
(#2)using 2 x #10-24*1/2"(#C)as Fig.14
shown.
Fig.12
Fig.13
Fig.14
11
14