Installing The Cart To The Barrel; Securing The Door Stopper, Door Magnet; Attaching The Cabinet Door Handle - Pit Boss PB820SC Mode D'emploi

Installation:
• Attach the cart back panel to the rear support legs of the cart, and
secure the inside edges using four screws. Repeat the same installation
to mount the two cart side panels to the other support legs.
NOTE: Once installed, the exterior of the cart panels are flush with
the support legs and bottom shelf.

4. INSTALLING THE CART TO THE BARREL

Parts Required:
Main Barrel (#12)
1 x
16 x Screw (#A)
16 x Locking Washer (#C)
16 x Washer (#B)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit.
Lay the main barrel on its side, hopper end pointed upward, on the
cardboard. Note illustration 4A.
• Insert the assembled cart into the main barrel brace, and secure each
leg to the main barrel brace using four washers, locking washers, and
screws. Repeat same installation for other three support legs, leaving
the bottom side (facing the ground) unsecure. Note illustration 4B.
IMPORTANT: Lock caster wheels before lifting grill upright.
• Carefully, lift the grill into an upright position with the wheels on the
bottom. Secure the final side of the grill using four washers, locking
washers, and screws.

5. SECURING THE DOOR STOPPER, DOOR MAGNET

Parts Required:
Door Stopper (#19)
1 x
1 x Door Magnet (#20)
2 x Screw (#D)
Installation:
• Remove the two pre-installed screws in the center of the bottom
shelf. Secure the door stopper to the same area using the two screws,
with the raised stop facing the back of the cart.
• Directly above, mount the door magnet using two screws. Ensure the
raised magnet is facing the front of the cart.
6. ATTACHING THE CABINET DOOR HANDLES
Parts Required:
Cabinet Door (#27)
2 x
Cabinet Door Handle (#26)
2 x
4 x Cabinet Door Bezel (#25)
Installation:
• Remove the pre-installed screws from the cabinet door handle. From
the rear of the cabinet door, insert one screw so that it protrudes to the
8
4A
4B
A
5
6
C B