Table des Matières
Publicité
* Do not let anyone come close to the machine while in use;
* Do not remove, cover or change the plates that are on the machine and, if they are damaged, contact
qualified and authorised personnel;
* Do not remove the transparent protection and do not change or exclude the mechanical and electrical
protections;
* Only slice permitted products; do not try slicing any products that are not allowed;
* The area around the machine, where the food is laid and the floor where the operator works must always
be kept clean and dry;
* Do not use the machine as a support surface and do not place any object on it that does not pertain to
normal cutting operations;
* Do not use the slicing machine when, after a normal use, the distance between the cutting edge of the
blade and the blade protection ring is over 6 mm. (see paragraph 7.2);
* Do not use the machine with electrical connections of a "temporary" nature, with temporary or not insulated
wires;
* Periodically check the state of the mains cable and the cable gland on the machine body, when necessary
have it replaced without delay by qualified personnel;
* Immediately stop the machine in the case of a defect, anomalous function, suspected breakage, incorrect
movements, unusual noise;
* Before cleaning or carrying out any maintenance, disconnect the machine from the electric mains supply;
* Use protective gloves for cleaning and maintenance;
* The goods to be cut must be placed on and removed from the sliding plate with the carriage in a retracted
position and the thickness regulating knob in the "O" position;
* Only use the moving handle placed on the arm or the handle on the food press for moving the food plate
during slicing;
* The use of accessories for cutting is not allowed unless supplied by the maker specifically for the
machine;
* For any exceptional maintenance (replacing grindstones, blade, etc.) please contact the manufacturer or
qualified and authorized personnel.
2.2 GUARANTEE AND MANUFACTURER'S RESPONSIBILITY
The guarantee of a good function and a complete conformity of the machines, that are to be used
accordingly, depends on the correct application of the instructions contained in this manual.
The manufacturer declines all direct and indirect resposibility deriving from:
- Not following the instructions in the manual;
- Untrained personnel using the machine;
- Using the machine so that it does not conform to specific regulations in force in the country of installation;
- Unauthorized changes and/or repairs to the machine;
- The use of accessories and spare parts that are not original;
- Outstanding events.
If the machine is sold or given away, this automatically means that the manufacturer is no longer responsible
for the machine in question except for anything regarding the EEC directive 85/374 (responsibility for any
construction faults of the product).
2.3. THE USER'S OBLIGATIONS
The user must scrupulously observe the instructions in this manual for the manufacturer's guarantee to be
valid and particularly:
- always respect the limits of the machine;
- always carry out a constant and diligent maintenance;
- make sure the persons using the machine are qualified and able.
2.4. MARKINGS - PLATES
The following plate is installed on the machine:
- manufacturer's identification plate, machine plate, technical data plate and EC marking; placed on the
base, left- hand side.
10
Uso e manutenzione - Use and maintenance
Publicité
Table des Matières
