Set Standard Signal For Set-Point Position; Select Physical Unit For Process Control - Burkert 3360 Guide Rapide

Type 3360, 3361
9.6 Set standard signal for set-point
position
Configuration option:
Using the Bürkert Communicator PC software or the
display of the device (optional).
Display operation: Button functions
Select, activate
To set the standard signal, switch to the "Parameters" detailed
view for inputs/outputs.
How to switch to detailed view:
→
When using Bürkert Communicator for the configuration,
select in the navigation area.
Inputs/Outputs
→
When using the display for the configuration, switch to
on the home screen and select
CONFIGURATION
Outputs.
You are now in the "Parameters" detailed view.
How to configure the standard signal:
→
Select CMD.
→
Select ANALOG.type.
→
Select standard signal.
The standard signal is now configured.
Start-up
Confirm Back
Inputs/
9.7 Select physical unit for process
control
Configuration option:
Using the Bürkert Communicator PC software or the
display of the device (optional).
Display operation: Button functions
Select, activate
To select the physical unit, switch to the "Parameters" detailed
view for process controllers.
How to switch from view 1 to the detailed view:
→
When using Bürkert Communicator for the configuration,
select Process Controller
→
When using the display for the configuration, switch to
CONFIGURATION on the home screen and select
Controller.
You are now in the "Parameters" detailed view.
How to select the physical unit for process control:
→
Select UNIT.
→
Select physical unit.
T he physical unit is now selected.
English
Confirm Back
in the navigation area.
Process
37