Table Des Matières - Burkert 3360 Guide Rapide

Type 3360, 3361
QUICKSTART ..................................................... 4
1
1.1 Definition of terms ....................................................... 4
QUICKSTART ............................................................................... 4
1.2 Symbols ....................................................................... 5
2 INTENDED USE .................................................................... 5
3 BASIC SAFETY INSTRUCTIONS .......................................... 6
4 GENERAL NOTES ................................................................. 7
4.1 Contact address .......................................................... 7
4.2 Warranty ...................................................................... 7
4.3 Information on the Internet .......................................... 7
5 STRUCTURE AND FUNCTION ............................................. 8
5.1 Structure of the electromotive control valve ............... 8
5.2 Display of the device status ....................................... 9
6 TECHNICAL DATA ................................................................. 9
6.1 Conformity ................................................................... 9
6.2 Standards .................................................................... 9
6.3 Approvals .................................................................... 9
6.4 Type label .................................................................. 10
6.5 Operating conditions ................................................. 10
6.6 General technical data ............................................... 13
7 INSTALLING THE VALVE ..................................................... 16
7.1 Installation of devices with threaded connection,
flange connection or clamp connection .................... 16
7.2 Installation of devices with welded connections ....... 17
Contents
7.3 Rotating the actuator ................................................. 21
7.4 Holding device ........................................................... 22
8 ELECTRICAL INSTALLATION ............................................. 22
8.1 Electrical installation with circular plug-in connector 22
8.2 Electrical connection Fieldbus gateway .................... 25
8.3 Electrical installation with cable gland ...................... 26
9 START-UP ............................................................................ 32
9.1 Before start-up .......................................................... 32
9.2 Configuration options for start-up ............................. 32
9.3 Base settings ............................................................ 32
9.4 Set safety position ..................................................... 34
9.5 Adjustment of position controller - execute X.TUNE 35
9.6 Set standard signal for set-point position ................. 37
9.7 Select physical unit for process control .................... 37
9.8 Configure process values .......................................... 38
9.9 Scaling the process control ....................................... 39
9.10 Set dead band for process control ............................ 39
9.11 Setting up process control and executing P.LIN,
P.TUNE ...................................................................... 40
9.12 Setting the operating state ........................................ 41
10 OPERATION ........................................................................ 42
10.1 Display elements ............................................................. 42
10.2 Operating elements ................................................... 43
11 DISPLAY OPERATION (OPTIONAL) ................................... 44
11.1 User interface ............................................................ 44
11.2 Description of buttons ............................................... 44
English
3