Burkert 3360 Guide Rapide page 33

Type 3360, 3361
Before delivery, important basic settings have already been
input at the factory. See diagrams below.
9.3.1 Base settings for position control
Overview:
Type of base setting
(observe sequence)
1. Set safety position
Adjustment of position control
2.
(Function X.TUNE)
Set standard signal for set-point
3.
position
4 Set AUTOMATIC operating state MANUAL
Tab. 14: Base settings for position control
9.3.2 Base settings for process control
Overview:
Type of base setting
(observe sequence)
1. Set safety position
2. Adjustment of position control
(Function X.TUNE)
3. Select physical unit for process control
Start-up
Factory default setting
Close/open (dependent on
device variant)
Factory setting (see Page 32)
Signal type analogue: 4...20 mA
Gateway: Specified by Fieldbus
Factory default setting
Close/open (dependent on device
variant)
Factory setting (see Page 32)
Per cent
Type of base setting
(observe sequence)
4. Configure process values
a) Select standard signal for process
set-point value
b) Scale process set-point value
c) Select standard signal for process
actual value
d) Scale process actual value
5. Scaling the process control
6. Set dead band for process control
7. Set up process control
Linearising process characteristic
a)
(function P.LIN)
In addition for devices without a display: Set DIP switch 2 to ON to
activate the correction characteristic.
Adjust process control (P.TUNE
b)
2)
function)
8.
Set AUTOMATIC operating state
Tab. 15: Overview: Base settings for process control
1) Only necessary if process characteristic varies substantially from line-
arity. Linearisation using the function P.LIN can take a lot of time with
slow processes.
2) The P.TUNE function supports process control set-up by inde-
pendently optimising process parameters.
The process of fine-tuning process parameters is described in the Type
3360, 3361 software description.
English
Factory default setting
Signal type analogue: 4...20 mA
Gateway: Specified by Fieldbus
Minimum 0%, maximum 100%
4...20 mA
Minimum 0%, maximum 100%
Minimum 0%, maximum 100%
1%
-
1)
-
MANUAL
33