Introduction; User's Responsibility For Safety; Unpacking And Control; Electromagnetic Compatibility - Burkert 8225 Notice D'utilisation

1 INTRODUCTION

BEFORE INSTALLING OR USING THIS
PRODUCT, PLEASE TAKE OUR ADVICE
AND READ THE ENTIRE MANUAL THO-
ROUGHLY.
This will enable you to benefit fully from all
of the advantages which the product can
offer.

1.1 Unpacking and Control

Please verify that the product is complete
and free from any damage.
To ensure that you have received the
product required, please compare the Type
specification (Bürkert identification number)
on the label to the lists on the following
pages. If there are any problems such as
loss or damage, please contact your local
Bürkert subsidiary.
1.2 About this Manual
This manual does not contain any form of
warranty or statement and full referal to our
general terms of sale and delivery should be
noted.
This product should only be installed and/or
repaired by correctly trained staff. If any
difficulties may occur with the product
during installation, please do not hesitate to
contact your nearest Bürkert sales office for
assistance.
CONDUCTIVITY 8225

1.3 User's Responsibility for Safety

Bürkert manufactures a broad range of
conductivity transmitters designed to
operate in a wide variety of applications. It
is the customer's responsibility to select an
appropriate transmitter for the application,
ensure the unit is installed correctly, and
maintain all components. Special attention
must be made to the chemical resistance of
the transmitter and the fluids/medium which
maybe in direct contact with the product.
If this symbol appears, it
indicates that special attention
should be paid to the instruc-
tions, as they may affect the
safe installation, function or/
and use of the product.

1.4 Electromagnetic compatibility

This device fulfills the essential require-
ments of te directives 89/336/EC (EMC)
and 73/23/EC (DBT).
In order to comply with the directives, the
wiring instructions must be followed.
The device has been tested according to
the following EMC standards:
- EN 61000-6-3 (2001)
- EN 61000-6-2 (2001)
- EN 61010-1 (2001)
E-2-