Boston Scientific SC-5210 Manuel page 25

To Adjust Stimulation Pulse Width:
1. From the Level screen, press and hold
p or q to increase or decrease the Pulse Width.
2. To move to another area, press
screen (2, 3 or 4) that you want.
3. Press either p or q to increase or decrease the Pulse Width.
Note: The Remote Control will beep to notify you if you reach a preset limit while increasing or decreasing the Pulse Width.
To return to the Level screen from any Pulse Width screen, press and hold
again to see the Level screen. If you do not have access to the Rate option, the Level screen will appear right away.
To Adjust Stimulation Rate
1. From the Level screen make a long
Note: If you do not have access to the Pulse Width option, the long press will take you directly to the Rate Area 1 screen.
until you see the Width Area 1 screen. If this is the area you want to adjust, press either
"
briefly (a "normal" press) to cycle through your programmed areas until you find the Width Area
"
button press to Pulse Width Area 1.
"
until Rate Area 1 is displayed, then press and hold
"
Patient System Handbook
9055960-003 REV B 23 of 233
The Remote Control
"