Getting Started - Boston Scientific SC-5210 Manuel

Patient System Handbook

Getting Started

WARNINGS:
• Do not charge while sleeping. This may result in a burn.
• While charging, the Charger may become warm. It should be handled with care.
• Failure to use the Charger with either the Charger Belt or an adhesive patch, as shown, may result in a burn. If you experience
pain or discomfort, cease charging and contact your healthcare professional.
The Charging System for your Stimulator consists of the Charger unit, a Base Station, and a Power Supply. The Base Station is
designed to remain connected to a power outlet at all times. When it is not being used, keep the Charger on the Base Station so that it
is always ready to deliver a charge.
1. Find a convenient place with a flat, clear surface to keep the Base Station plugged in.
2. Without plugging anything into your AC wall outlet, select the plug that matches your standard AC wall outlet, then fully insert this
plug into the Power Supply.
3. Plug the Power Supply, into a standard AC wall outlet, then plug the other end into the Base Station connector.
4. Place the Charger in the Base Station.
When charging, you must use the Charger with either the Charger Belt or an adhesive patch to hold the Charger over the Stimulator.
The adhesive patches are made of non-reactive material suitable for most sensitive skin types.
Note: Using the Charger Belt is the recommended method for charging.
Patient System Handbook
9055960-003 REV B 30 of 233