Patient System Handbook
2. When the named or numbered area that you want to adjust is shown on the screen, press p or q to change the stimulation level
for that area.
The screen will go blank and the Remote Control will go to "sleep" after one minute of inactivity.
Programs
A stimulation program may provide paresthesia to cover a single pain area, or up to four areas, depending on how the program was
set up by your clinician. Your Remote Control can store up to four programs—numbered 1 through 4—for you to select and activate
at any time. Often, the programs will have certain differences in the settings to allow you to vary your stimulation in several ways. You
may have been encouraged to try using specific programs for different circumstances, or different body positions, or different times
in your daily routine. Programs and their flexibility give you and your healthcare professional a way to continually "fine tune" your
therapy.
Selecting and Activating Programs
P
1. Press the
button from the Level screen to go to the Program screen.
From the Program screen, each additional
program number. The black highlight box shows where you are in the cycle. Pressing
screen. Pressing
from program 1 also returns you to the Level screen.
"
Patient System Handbook
9055960-003 REV B 18 of 233
P
button press selects the next program number. Press
to select the previous
"
P
from program 4 returns you to the Level