Boston Scientific SC-5210 Manuel page 40

Patient System Handbook
"Error Code" on the Display
If the Remote Control displays the error screen shown at right, try to make a note of the numbers (the error code) on the top line.
P
Then press , wait a few seconds, move the Remote Control closer and try the action again.
Since most of the error codes you might encounter are related to communication, always try to resolve the problem by moving the
Remote Control closer to the Stimulator. If this does not work, please contact your health care professional.
P P
Note: The Remote Control will go to the Level screen when
is pressed, or to idle mode if is not pressed within one minute.
Patient System Handbook
9055960-003 REV B 38 of 233