Boston Scientific SC-5210 Manuel page 35

5. Secure the Charger over the Stimulator either by pressing the adhesive to the skin
over the Stimulator, or by securing the Charger Belt.
Note: If you accidentally locate the patch in the wrong place, or if the Charger Belt
moves out of alignment, the Charger will start beeping again. Use a new
adhesive patch or readjust the belt to place the Charger back into position.
6. When the Charger emits a distinct double beep, the Stimulator is charged. Switch
off the Charger, remove the Charger Belt or adhesive patch, and return the Charger
to the Base Station.
Do not confuse the end of charge signal (a distinct double beep) with the steady,
continuous misalignment signal.
Note: • Depending on your program parameters, you may expect daily recharging
times from as low as 10 minutes up to four hours, or weekly recharging times
from as low as one hour up to four hours.
• The end of a charge signal is a distinct double beep, and the alignment indicator is a steady continuous signal.
Charging the Stimulator
Patient System Handbook
9055960-003 REV B 33 of 233