Inserting The Module - Burkert 8285 El. COND Mode D'emploi

Inserting the module

Note: Be sure to connect the shielding properly!
1. Switch off power supply
2. Open the device (loosen the 4 screws at the front)
3. Place module in slot (D-SUB connector)
4. Tighten fastening screws of the module
5. Connect sensor cable.
6. Close device, tighten screws at the front
7. Switch on power supply
8. Set parameters
Caution!
Be sure to select the sensor type you are using in the
parameter setting menu!
Make sure that the cable
glands are tightly closed to
protect against humidity.
17