Type T-CUT
ProductInformation
5
PRODUCT INFORMATION
5.1
Intended Use
The intended use of the T-CUT tubular/pipe module is to concentrate or filter medium components by separating
the solvent in which they are to be found.
The T-CUT tubular/pipe module has been designed for media that does not attack the membrane material (refer
to product-specific data sheet).
This product may only be used following detailed consultation with a representative of Bürkert Fluid
Control Systems.
We recommend practical testing to support the theoretical basis for successful substance separation. Advance
laboratory or pilot reference trials will provide information on the flow rates and purity of the permeate.
5.2
Handling of the Module
5.2.1
Protection against Drying
The module is well packed and supplied with sealed connections. When the module is in storage, there is the
risk that the membrane may dry out. This may cause irreversible damage to the membrane and must therefore be
absolutely avoided (refer to "13 Non-use/Module Storage")
5.2.2
Protection against UV
Do not subject the module to long-term exposure to direct sunlight or other UV sources (e.g. UV disinfection
lamps).
Store the module in a dark place.
5.2.3
Protection against Frost
Store and use the module in a place protected against frost. If the module freezes, this will damage the mem-
brane and result in brittle fractures.
5.2.4
Protection against Solvents
If the module housing comes into contact with organic solvents or if adhesive rubber tape is used, the housing
may break.
To remove soiling from the housing, it should be cleaned with water or ethanol.
5.2.5
Careful Transport
If the module falls or is subjected to other collisions, this may result in fractures in and on the module and on the
connectors. Therefore, the module must be transported and handled with care.
english
9