Burkert 8285 El. COND Mode D'emploi page 51

Activating Calculation Blocks
Menu selection: Parameter setting/System control/Calculation Blocks
Combining 2 COND measuring modules to Calculation Blocks
Combination of 2 COND measuring modules
With three measuring modules the following Calculation Block combinations
are possible:
Two Calculation Blocks can be activated.
Menu Display
System control (Administrator)
Calculation Blocks
Tag number
Release of options
Logbook
Concentration table
Factory setting
Return
Calculation Blocks (Administrator)
Block 1
Block 2
Return
Parameter setting (Administrator)
System control
Module 8285 FRONT
Module 8285 BASE
Module 8285 El. COND
Module 8285 El. COND
+ Calc Cond/Cond
Return
I + II , I + III ,
40.00 µS/cm
25.6 °C
40.00 µS/cm
25.6 °C
Off
Calc Cond/Cond
40.00 µS/cm
25.6 °C
II + III
Activating Calculation Blocks
Calculation Blocks
• Activating parameter setting
• System control
• Select "Calculation Blocks"
• Depending on the modules
installed, the possible combina-
tions for Calculation Blocks are
offered.
During parameter setting the
Calculation Blocks are displayed like
modules.
51