Calculation Blocks - Burkert 8285 El. COND Mode D'emploi

Calculation Blocks

Menu selection: Parameter setting/System control/Calculation Blocks
Calculation of new variables from measured variables
Calculation Blocks
Two measuring modules with all their measured values serve as input for the
calculation block. In addition, the general device status (NAMUR signals) is
taken into account. The difference between the existing values is calculated:
Current outputs
All current outputs can be set to output the new process variables formed by
the Calculation Blocks.
Measurement display
All new process variables can be displayed as primary or as secondary value.
Controller
Controller functions are not supported.
Functionality of measuring module
Inputs:
Sensors, terminals
Cond
Temp
Functionality of Calculation Block
Inputs:
Outputs of 2 measuring modules
Module
I
Module
II
50
Measuring
module
Module I
e.g.:
Cond module
Calculation Block
Module I + II
Cond/Cond
Outputs
Measured values / Status
S/cm
Ω*cm
°C
% by wt
g/kg
°F
Outputs:
Measured values / Status
S/cm diff
Ω*cm diff
°C-Diff
Ratio
Passage
Rejection
Deviation
8285