How To Use The Cable Clips; Compact Version, 12-30 Vdc, With Cable Glands, Without Relay - Burkert 8225 Notice D'utilisation

Masquer les pouces Voir aussi pour 8225:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3 INSTALLATION

3.2.3 How to use the cable clips

Before wiring the device, insert the supplied
cable clips into the cuts of the electro-
nic board and, if fitted, into the cut of the
115/230 VAC power supply board.
3.2.4 Electrical wiring, compact version, 12-30 VDC, with cable glands,
without relay
Before wiring the device, please read § 3.2.1 and 3.2.3 carefully.
Lift the transparent lid after having unfastened the screw. Remove the cover of the device by
unscrewing the 4 screws, pass the cables through the cable glands and connect according
to the pin assignment below.
Always seal the unused cable gland using the supplied obstructor to
ensure the tightness of the device.
Unscrew the cable gland nut, insert the obstructor and screw the nut back
onto the cable gland.
Fig. 3.6
Wiring, compact transmitter, 12-30 VDC, with cable glands, without relay
L- (0V)
L+ (12-30 VDC)
Not used
E-20-
CONDUCTIVITY 8225
Fig. 3.5
Using the cable clips
Connect the power supply cable shielding
Connect the conductivity sensor

Publicité

Table des Matières
loading

Table des Matières