Installing The Copilot Receiver - MINN KOTA COPILOT Manuel Du Propriétaire

INSTALLATION

Installing the CoPilot Receiver

1
a. Make sure that the Power Cables from the
battery are disconnected, or that the breaker,
if equipped, is "off".
WARNING
Make sure the motor is mounted on a level surface and is
not connected to a power source.
2
b. Using a #2 Phillips Screwdriver, remove the four
1/4-20 x 5/8'' Screws from the Right Sideplate
and Left Sideplate of the PowerDrive mount.
3
c. Remove the Right Sideplate.
d. Swing the Left Sideplate out and away from the
Base Extrusion.
3c
©2016 Johnson Outdoors Marine Electronics, Inc.
3d
Right Sideplate
Power Cables
Sideplate Screw
Base Extrusion
Left Sideplate
INSTALLATION
minnkotamotors.com | 7