Adjusting The Depth Of The Motor; Installing An External Transducer - MINN KOTA RIPTIDE SP Manuel De L'utilisateur

USING & ADJUSTING THE MOTOR

ADJUSTING THE DEPTH OF THE MOTOR

When setting the depth be sure the top of the motor is submerged
at least 12" to avoid churning or agitation of surface water. The
propeller must be completely submerged.
1. With the motor deployed, fi rmly grasp the composite shaft above
the mount.
2. Loosen the adjustable depth collar until the shaft slides freely.
3. Raise or lower the motor to the desired depth.
4. Turn the motor control head to the desired position.
5. Tighten adjustable depth collar to secure the motor in place.

INSTALLING AN EXTERNAL TRANSDUCER

An external sonar transducer can be installed onto the motor as shown.
1. Transducer cables should be routed through the coil cable as
depicted in the illustration to the right.
2. Leave enough slack for proper stow and deploy.
3. Mount transducer according to transducer instructions.
Note: An external transducer is not included with your trolling motor.
Your trolling motor may be pre-installed with a Universal Sonar 2
transducer system. In this case, the transducer is integrated into the
motor unit.
For compatibility and more information on Universal Sonar 2, please
visit minnkotamotors.com/us2.
ACCESSORY RECOMMENDATIONS:
• Minn Kota Transducer Mounting Kit (MKR-15)
12 | minnkotamotors.com
Motor Control Head
Composite Shaft
Composite Shaft
Adjustable Depth Collar
Adjustable Depth Collar
Motor Mount
Motor Mount
Tie wrap cable
Tie Wrap
Cable
Leave slack
Transducer
Transducer cable
cable
Leave slack
Leave slack
Tie Wrap
Cable
Tie wrap cable
Transducer
Transducer
©2015 Johnson Outdoors Marine Electronics, Inc.
12" Minimum Depth
12" Minimum Depth