Adjusting The Depth Of The Motor; Adjusting The Steering - MINN KOTA 1355920 Mode D'emploi

ADjUSTING THE DEPTH OF THE MOTOR

MOTOR ADjUSTMENTS
Adjusting the Depth of the Motor
When setting the depth be sure the top of the motor is submerged at least 12" to avoid churning or agitation of surface water. The
propeller must be completely submerged.
1
a. With the motor deployed, firmly grasp the Outer
Shaft or Control Head and hold it steady.
b. Loosen the Depth Adjustment Knob until the Shaft
slides freely.
c. Raise or lower the motor to the desired depth.
d. Turn the motor Control Head to the desired position.
e. Tighten the Depth Adjustment Knob to secure the
motor in place.
NOTICE:
Be sure the top of the motor is submerged
at least 12" below the surface of the water to avoid
churning or agitation of surface water.
WARNING
The motor head will create a pinch point if the Depth
Adjustment Knob is loosened and the motor Control Head
slides to the top of the Mount. Grasp the Shaft and prevent
it from sliding all the way down to prevent the pinch point.
Grasp the motor away from the area that may come in
contact with another area of the motor to prevent injury.

Adjusting the Steering

Adjust the Steering Tension Knob to provide enough tension to
allow the motor to turn freely, yet remain in any position without
being held or tighten the knob to place the motor in a preset
position to leave your hands free for fishing.
18 | minnkotamotors.com
Motor Shaft Motor Shaft
12" Minimum 12" Minimum
Depth Depth
Steering Steering
Tension Knob Tension Knob
©2021 Johnson Outdoors Marine Electronics, Inc.
Depth Depth
Adjustment Adjustment
Knob Knob