Panic Recording - Lorex L23WD Série Mode D'emploi

Using the Recording Menu

Panic Recording

Use the Panic Recording menu to set camera
parameters for each channel during panic
recording.
Figure 16.14 Panic Recording menu (16-channel model shown).
By default, the system is set to record
NOTE:
at the highest quality recording parameters
during Panic Recording.
To set panic recording parameters:
1. Click the PANIC RECORDING tab on the
left.
• The Camera Parameters window opens.
Figure 16.15 Camera parameter window (16-channel shown).
2. From the Camera Parameters window,
configure the following:
• SIZE: Select from 352x240, 704x240, or
704x480 (default).
• FPS: Select from 1, 2, 3, 7 (default), 15, or
30 frames-per-second (real-time
recording) from a shared pool of 127
80
• QUALITY: Select from LOW, STANDARD,
HIGH, HIGHEST or SUPER.
• AUDIO: Select ON/OFF for the desired
channel(s).
The system can record a maximum of
NOTE:
four audio channels simultaneously.
3. Click OK to save your settings.
• The Camera Parameters window closes.
4. Click APPLY to save your settings or click
CANCEL to restore defaults.
5. Select CLOSE to exit.
FPS.