Basic System Setup; Connect The Cameras - Lorex L23WD Série Mode D'emploi

Basic System Setup

BASIC SYSTEM SETUP

1. CONNECT THE CAMERAS*

• Connect DIN cameras to the DIN Video In ports in the connection panel. The DIN camera
connectors go in one way only. Do not force. Ensure the flat side of the DIN cable faces out.
• Connect BNC cameras to the BNC Video In ports in the connection panel. Connect the BNC
power cord to the power adapter.
If a BNC camera and a DIN camera occupy the same channel, an unclear overlapped
NOTE:
image may appear in the channel. Ensure that the DIN and BNC cameras occupy different
channels.
BNC ports
Figure 2.0 Connecting the cameras . 16-channel
configuration shown.
* Camera type may vary. Check your package contents for details.
8
DIN Channel 1
DIN Channel 2
Tilt the display for easy access to the rear panel
DIN ports
DIN Channel 3
DIN Channel 4
Male DIN connector
Ensure the flat side of the DIN
cable faces away from the monitor.